SELF LEVELLING CEMENTS

SL 50 – SELF LEVELLING CEMENT

Auscon SL 50 Self Levelling Cement is a blend of Portland cement, graded aggregates and additives designed to give a self-levelling finish as a floor underlayment. It is self-levelling, rapid setting and open to light foot traffic in 4 hours. Superior crack resistance due to low shrinkage and exceptional bond. Used in indoor areas over concrete substrates. It is pumpable or can be mixed with a shear blade mixer and placed manually to a thickness up to 30mm.

Minimum MPa
MPa @ 28 days
Water / 20kg
Application Thickness
Flowable 35 5.0 litres 1 – 30 mm

FF 8 – FEATHER FLOOR PATCH

Auscon FF 8 – Rapid Set Feather Floor Patch, is an underlayment floor patching and Skim coat that is used under surfaces to provide a smooth hard flat finish prior to the installation of floor coverings, vinyl, tiles and carpet. Its fast setting 20 minutes, speeding up installation and with exceptional bonding strength.

FS 35 – FLOOR SCREED CEMENT & SAND MIX

Auscon FS 35 Tilers Screed is designed to be used over concrete, fibre cement floors before laying waterproofing, tiles, and pavers. It is a pre-mixed blend that is 1 part cement and 3 part sand, ideal for achieving falls for water run-off, or levelling uneven concrete floors. Suitable for internal and external use.

Minimum MPa
MPa @ 28 days
Water / 20kg
Application Thickness
Flowable 30 2.0 litres 5 – 40 mm

SLR 20 – FIBRE REINFORCED SELF-LEVELLING CEMENT

Auscon SLR 20 Fibre Reinforced Self-Levelling Cement is a fibre reinforced self-levelling underlayment used for interior levelling of new or existing concrete and timber floors. Suitable for use in domestic or commercial environments, it will produce a smooth and level finish in uneven floors of 3-30mm differences in a single application. It can be used in commercial or industrial application as a finish application, provided a coating is applied over SLR 20. Most floor coverings can be applied after 16-22 hours, approximately.