HIGH STRENGTH GROUTS

GT 90 – HIGH PERFORMANCE PT GROUT

Auscon GT 90 High Performance PT Grout is high flow, shrinkage-compensated, aluminate free, pre-blended post-tensioning cement grout. It has no added sand, making it ideal for grouting post-tensioned cables, anchors, cable tendons and re-bar. Superior early high strength gain allowing early tensioning of anchors. With modern building techniques slowly replacing the use of steelwork with other means of support, the need for a high strength pre-mix PT grout becomes ever more relevant making the Auscon GT 90 the ideal grouting product.

Minimum MPa
MPa @ 3 Days
MPa @ 7 Days
Water / 20kg
Flowable 50 MPa 65 MPa 7.1 – 7.2 litres

SHS 120 – RAPID SET HIGH STRENGTH CEMENT GROUT

Auscon SHS 120 Rapid Setting Non Shrink Grout is a Class-C one-component cement powder which requires only the addition of water to form a rapid setting high-strength,non-shrink cement grout. It is shrinkage compensated grout suitable for civil engineering applications, where a quick and high early strength is required. It incorporates specially graded aggregates and advanced new generation polymers to form a cementitious grout. Firms in approximately 30 minutes.

Minimum MPa
MPa @ 24 hrs
Water / 20kg
Application Thickness
Flowable 40 3.8 – 3.9 litres 10 – 80 mm

HS 90 – HIGH STRENGTH CEMENT GROUT

Auscon HS 90 is a one component cement powder which requires only the addition of water to form a high strength non shrink cementitious grout. It is a pump-able and shrinkage compensated grout suitable for civil engineering applications. It incorporates specially graded aggregates and advanced new generation polymers to form a cementitious grout.

Minimum MPa
MPa @ 28 days
Water / 20kg
Application Thickness
Flowlable 75 3.8 – 3.9 litres 10 – 80 mm

GP 50 – GENERAL PURPOSE NON-SHRINK GROUT

Auscon GP 50 General Purpose Non-Shrink Grout is a Class-A new-generation, one-component cement blended powder which requires only the addition of water to form a high strength grout. It is a pumpable, shrinkage compensated product suitable for civil engineering applications. It incorporates specially graded aggregates and advanced polymers to form a non-shrink cementitious grout.

Minimum MPa
MPa @ 28 days
Water / 20kg
Application Thickness
Flowable 55 3.8 – 3.9 litres 10 – 100 mm

SS 50 – SUPER-STICK SHOTCRETE

SS 50 Super stick Shotcrete is a blended cement mix that is sprayed at high velocity onto a surface. It is possible to place the Auscon shotcrete using the dry-mix process, where most of the mixing water is added in close vicinity to the nozzle or the wet-mix method where all the ingredients, including water are mixed before introduction into the hose. Auscon SS 50 is specifically designed for either dry-mix or wet-mix shotcrete process.